UV Permanent Stickers

UV permanent stickers are built to last, engineered for strong adhesion, vibrant color, and resistance to wear. Follow these simple steps to ensure a flawless application and long-term durability.

‍

How to apply?

1. Clean the surface: Make sure the area is completely dry, smooth, and free of dust, oil, or residue.
2. Peel the backing carefully: Avoid touching the adhesive side to keep it clean and strong.
3. Place and press firmly: Position the sticker exactly where you want it, then press down starting from the center outward, press firmly on all areas to make sure the Sticker is firmly stuck to the surface. Let the sticker rest for 1 minute on the surface
4. Smooth out air bubbles: Use your fingers or a flat edge (like a card) to push out any trapped air.
5. Once the sticker is fully applied, SLOWLY PEEL the edge of the clear sticker film and start to remove. CONTINUE to peel clear film away by rolling it off while applying pressure. Do not pull the clear film up. Pull towards the direction you are peeling off.

Once applied, it’s permanent. Place it with intention.

‍

Best Conditions for Application

‍

• Apply at room temperature (ideally 10–30°C / 50–86°F)
• Avoid applying on extremely cold, hot, or wet surfaces
• Ensure the surface is non-porous for best adhesion
  ‍

Long-Term Care Tips

‍

• Allow to cure: Let the adhesive set for 24 hours before heavy use or washing
• Clean gently: Use mild soap and water; avoid abrasive scrubbers
• Dishwasher safe (top rack): For bottles and containers, when fully cured
• Weather-resistant: Suitable for indoor and outdoor use

‍

What to Avoid

‍

• Applying to dirty, oily, or uneven surfaces
• Repositioning after placement (adhesive may weaken)
• Harsh chemicals or solvents
• High-pressure scrubbing directly on the edges

‍

Built to Stick. Made to Last.

‍

UV permanent stickers are designed for durability across everyday wear and tough environments, keeping your branding, labels, and designs looking sharp over time.